Publications

Microwave atomic clocks have traditionally served as the 'gold standard' for precision measurements of time and frequency. However, over the past decade, optical atomic clocks have surpassed the precision of their microwave counterparts by two orders of magnitude or more. Extant optical clocks occupy volumes of more than one cubic...

The quality of epitaxial layers in quantum cascade lasers (QCLs) has a primary impact on QCL performance, and establishing correlations between epitaxial growth and materials properties is of critical importance for continuing improvements. We present an overview of the growth challenges of these complex QCL structures; describe the metalorganic vapor...

Pump-limited kW-class operation in a multimode fiber amplifier using adaptive mode control and a photonic lantern front end was achieved. An array of three single-mode fiber inputs was used to adaptively inject the appropriate superposition of input modes in a three-mode gain fiber to achieve the desired mode at the...

Operation of a cw thulium laser emitting at 816 nm has been demonstrated in bulk Tm:YLF with 46% slope efficiency. Prior cw demonstrations of this transition have been limited to ZBLAN fiber hosts and prior lasing in bulk crystalline host material has been limited to quasi-cw operation due to population...

Laser strikes against aircraft are increasing at an alarming rate, driven by the availability of cheap powerful lasers and a lack of deterrence due to the challenges of locating and apprehending perpetrators. Although window coatings and pilot goggles effectively block laser light, uptake has been low due to high cost...

A multistage cryogenic chirped pulse amplifier has been developed, utilizing two different Yb-doped gain materials in subsequent amplifier stages. A Yb:GSAG regenerative amplifier followed by a Yb:YAG power amplifier is able to deliver pulses with a broader bandwidth than a system using only one of these two gain media throughout...

We report a photothermal modulation of Mie scattering (PMMS) method that enables concurrent spatial and spectral discrimination of individual micron-sized particles. This approach provides a direct measurement of the "fingerprint" infrared absorption spectrum with the spatial resolution of visible light. Trace quantities (tens of picograms) of material were deposited onto...

We investigate high brightness pumping of a multi-kW Yb fiber amplifier in a bi-directional pumping configuration. Each pump outputs 2 kW in a 200 um, 0.2 NA multi-mode fiber. Gold-coated specialty gain fibers, with 17 um MFD and 5-dB/meter pump absorption, have been developed. The maximum fiber amplifier output power...

We demonstrate adaptive-spatial mode control (ASMC) in few-moded double-clad large mode area (LMA) fiber amplifiers by using an all-fiber-based photonic lantern. Three single-mode fiber inputs are used to adaptively inject the appropriate superposition of input modes in a multimode gain fiber to achieve the desired mode at the output. By...

We present design, packaging and coherent beam combining of quantum cascade amplifier (QCA) arrays, measurements of QCA phase noise, the drive-current-to-optical-phase transfer function, and the small signal gain for QCAs.