Publications

This paper describes a semiautonomous approach to calibrate a phased array system, with particular use on an S-band aperture that is being developed at MIT Lincoln Laboratory. Each element of the array is controlled by an independent digital phase shifter, whose control signal may be uniquely defined. As active electronically steerable arrays (AESAs) continually evolve towards mostly digital paradigms that will support real-time computing, as opposed to look-up table approaches, then adaptive calibration approaches may be pursued for maximum AESA performance. This calibration work is being completed as one component of Lincoln Laboratory's effort within the multifunction phased array radar (MPAR) initiative.

This paper describes a method to answer the following questions: can several of the elements of a phased array be employed as auxiliary (AUX) elements and how can the phase of each be adjusted so that the (1) cross-polarization (cross-pol) isolation is minimized to 40 dB, (2) the sidelobe levels of the main lobe are minimally impacted, and (3) the width and height of the main lobe are minimally impacted? This calibration work is being completed as one component of Lincoln Laboratory's effort within the multifunction phased array radar (MPAR) initiative. Devoting a few of the elements to serve as the AUX channels to specifically operate to mitigate the effects of the cross-pol influence, the distributed sidelobe levels will not suffer much impact; yet, the impact of the AUX elements will have deepened the cross-pol isolation at the peak of the co-polar beam can occur because the AUX elements can achieve a high degree of narrowband angular resolution.

MIT Lincoln Laboratory is working towards the development of a tileable radar panel to satisfy multimission needs. A combination of custom and commercial off-the-shelf (COTS) Monolithic Microwave Integrated Circuits (MMICs) have been developed and/or employed to achieve the required system functionality. The integrated circuits (ICs) are integrated into a low cost T/R module compatible with commercial printed circuit board (PCB) manufacturing. Sixty-four of the transmit/receive (T/R) modules are integrated onto the aperture PCB in an 8x8 lattice. In addition to the T/R elements, the aperture PCB incorporates transmit and receive beamformers, power and logic distribution, and radiating elements. The aperture PCB is coupled with a backplane PCB to form a panel, the line replaceable unit (LRU) for the multifunction phased array radar (MPAR) initiative. This report summarizes the evaluation of the second iteration LRU aperture PCB and T/R element. Support fixturing was developed and paired with the panel to enable backplane functionality sufficient to support the test objective.